Hi,

i am a junior student doing a research to take part in a world competition, a very important chapter of my research paper depends on gases separation to benefit from each one at a time, i searched about gases separation techniques but i found most of them very expensive and complex. Lately, i found out a method depends on an electronic device that separates gases according to their different densities under high temperature amounts to 1200 C in a closed system. Please could any one recommend me a book/reference/research paper/any thing explain me this technique or any thing explains gases separation by density in general because i strongly need it.

Thanks in advance...

Edited October 20, 20169 yr by Haya

Which gases are you wanting to separate?

 

Are you researching uranium enrichment?

Which gases are you wanting to separate?

 

Are you researching uranium enrichment?

i want to separate gases produced from the combustion of organic matters (co2, h2o, and other minor gases)to benefit from each one at a time.

i want to separate gases produced from the combustion of organic matters (co2, h2o, and other minor gases)to benefit from each one at a time.

 

The most economic methods of achieving this are based on gas scrubbing. (see https://en.wikipedia.org/wiki/Scrubber)

 

But that does not make them necessarily profitable, There are generally cheaper methods of generating these gases.

 

Separation by density difference is a very expensive method, and very limited in its application.

 

The most economic methods of achieving this are based on gas scrubbing. (see https://en.wikipedia.org/wiki/Scrubber)

 

But that does not make them necessarily profitable, There are generally cheaper methods of generating these gases.

 

Separation by density difference is a very expensive method, and very limited in its application.

very expensive!! i know someone who did this with a cost up to only 5 or 6 dollars!! here is the device which this one made :(click on the photo so that you can see it clearly:

http://www8.0zz0.com/2016/10/21/08/241831114.jpg

Good luck with finding a backer.

very expensive!! i know someone who did this with a cost up to only 5 or 6 dollars!! here is the device which this one made :(click on the photo so that you can see it clearly:

http://www8.0zz0.com/2016/10/21/08/241831114.jpg

No, you know someone who says they can do it for a few dollars.

Good luck with finding a backer.

 

 

No, you know someone who says they can do it for a few dollars.

okay .... thank you so much for helping me!