Jump to content

Grant Knight

Members
  • Posts

    2
  • Joined

  • Last visited

Everything posted by Grant Knight

  1. DMSO is practically odourless, virtually non-toxic in small quantities, it is used in skin patches to aid in transferring medication across the skin barrier. It is also used to cryo-preserve tissue for transplant. Merged post follows: Consecutive posts merged Hi DrDNA, The melting point of DMSO is about 18 degrees C, boiling point about 189 degrees C. It can ge aerosolised and vaporised at about 40 -50 degrees. It is not a good idea to get both a toxic substance and DMSO on your skin because the DMSO greatly enhances monement across the skin. With the style of fumigation I decribed, above, there is no handlling of the chemicals. They are all injected mechanically into the closed shipping container.
  2. Dear Forum Members. Worldwide, the most commonly used fumigant to rid shipping containers of pests is methyl bromide. It is highly efficient at doing this but it is being phased out, worldwide, because it is an ozone layer depleter. Methyl iodide (MeI) is being considered as a substitute fumigation gas. It is equally efficient but has a much shorter atmospheric lifetime (and negligible ozone depletion potential) but is much less volatile. It is proposed to use it in combination with heat treatment where hot air (~45 degrees C) containing about 25g of methyl iodide/cubic m is circulated through the container in a closed system. It is becoming less acceptable to discharge such a toxic material as MeI to the air, untreated, and I am looking for some way of adding a reagent to the circulating MeI to immobilise it/convert it to a non-toxic material inside the container, or discharge the MeI/hot air through an external reactor to do similar. A candidate for this is dimethyl sulphoxide which reacts with MeI to form a non-volatile sulfoxonium salt (CH3)3 SOI. Does anybody know if this would be a practical reaction to perform, in the gas phase, within the container, if DMSO was titrated into the circulating hot gas, as an aerosol, at the end of the decontamination time? Is the reaction time under these conditions sufficiently fast? Is there another (cheap, readily available, low toxicity, volatile as an aerosol @ ~40 - 45 degrees C) compound that would do a better job under these conditions than DMSO. I would greatly appreciate your thoughts and ideas, Grant Knight email grant.knight@maf.govt.nz
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.