Jump to content

Electrical resistivity in finite elements

Recommended Posts

Dear All,


Suppose I've got a medium (like a soil) of a homogeneous and constant resistivity Rho (in Ohm.km). This medium is put into a big cube of 1km side, then giving a km3 of my medium.


Now suppose I want to model my cube by an electrical circuit with resistors at each side of the cube. May I state that each resistor will be Rhox4 then ?


No suppose I divide my km3 into equal 8 cubes of 500m side each and suppose I still want to model this arrangement by electrical resistors. What should be the value of each resistor/side then if I need that the whole set still corresponds to a resistivity of Rho ? I propose Rhox9/2. Am I right ?


For these who know Matlab, can Matlab simulate this kind of 3-D electric circuit with cubes whose sides are resistors ? Is there any special module to perform this function ?


Thanks to All.



Link to post
Share on other sites

No. I have written an m-file for structural mechanics problems, but that was mainly for didactic purposes.


Of course, you could also use an actual finite element program, such as Comsol or NX, if you have access to such. Probably a lot easier to get into.

Link to post
Share on other sites

It deals with just about anything you want. It is also very expensive (like Matlab). I only have experience with modelling magnetic fields with it.


If you want open source: I have heard very good things about Elmer, but I have never used it. From a brief look years ago, I had the impression that it is slightly harder to get started with it.


Do you have any experience with finite element modelling? A warning: do not take lightly to getting into it, as getting decent results is not straightforward. Even results that look good can be rubbish.

Edited by Bender
Link to post
Share on other sites

Well caught, thank you very much for your support from the beginning. I'll not be involved myself into finite elements, but an engineering student will dot it for me. I've got a licence of CST, do you know this tool ?

One last question please : have you got any opinion on the resistor value of my cube edges ?


Kind Regards.

Link to post
Share on other sites

I don't know CST.


Just one remark for the resistor values: it is not the resistivity that changes, but the surface area. At first glance replacing a single resistor with four resistors of one fourth the resistance should work, at least in the principal directions. I don't know how accurate the results will be in a random direction.

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.