Jump to content

inertial reference frames


inkliing

Recommended Posts

I'm reviewing physics after ~30yrs of neglect, starting with Halliday & Resnick (and the internet).

 

Here's what I understand to be standard Newtonian/classical inertial frames:

1. There exists a set of reference frames, called inertial frames, in which mass, time, force, acceleration, etc. are (Galilean) invariant but position, velocity, translational and angular momentum, work, kinetic energy, etc. aren't.

2. Measurements in one inertial frame can be converted into measurements in another frame by a Galilean transformation of coordinates.

3. All inertial frames are in relative rectilinear motion.

4. Any two frames are inertial if and only if they measure the same accelerations for all particles.

5. A frame is inertial if and only if a perfect accelerometer at rest measures no acceleration.

Also:

6. A frame is inertial if and only if physical laws are observed to be in their simplest forms.

 

When I got to the Equivalence principle:

1. Inertial mass = gravitational mass.

2. No experiment can determine whether you're in a free falling elevator or an elevator floating out in space. It is understood that the free falling elevator is just above the Earth's atmosphere and that the elevator in space is far from any gravitational source. Also, the free falling elevator is small enough, and falls for a short enough time period, that tidal deviations are below the level of experimental detection.

 

I had the following problem: I realized that #5 above was not true in the classical sense. Given two observers, each with a damped-spring accelerometer, one observer is in free fall above Earth's atmosphere and the other is floating out in space, then each observer will see that both accelerometers measure zero acceleration, even though they are accelerating with respect to each other. Each observer knows that his zero acceleration measurement proves that he is in an inertial frame, but also can see that the other observer's accelerometer aslo measures zero acceleration, that that therefore the other observer must also be in an inertial frame. And yet each observer clearly measures, in thier own inertial frame, that the other observer is accelerating.

 

I had assumed I would be able to do classical physics without having to worry about relativity, and that I could do relativity when I was ready. I guess was wrong.

 

I tried several things to get around the problem:

1. #5 above isn't really Newtonian, it must actually be an idea from relativity. This doesn't work since it can clearly be seen that #3-#5 above are all more or less equivalent.

2. I reasoned that the speeds and gravitaional fields involved were not relativistic, that somehow then the problem should go away and that the frames involved should be able to be described as noninertial in the classical sense. But this leads nowhere, if my accelerometer reads zero. I'm in an inertial frame.

3. I tried to convince myself that the 2 observers can't read each other's accelerometer, i.e., a signal sent between them would somehow be messed up by some "relativistic effect," but I knew this was rediculous since the speeds and field strengths involved weren't relativistic.

 

I gave up and opened my old general relativity book (Gravitation by MTW). The 1st chapter describes inertial motion:

Following a geodesic (free fall, orbit, etc.) = natural (weightless) motion of a particle = local inertial (i.e., Lorentz) frame = particles move at constant speed in straight lines. Physics (physical laws) is simple when viewed locally.

 

So I tried to revise my definition of an inertial frame:

1. For any particle moving in Nature, there exists a set of local reference frames, called inertial frames, in which mass, time, force, acceleration, etc. are (Lorentzian) invariant but position, velocity, translational and angular momentum, work, kinetic energy, etc. aren't.

2. Measurements in one local inertial frame can be converted into measurements in another local frame by a Lorentzian transformation of coordinates (Galilean at low speed).

3. All local inertial frames are in relative rectilinear motion.

4. Any two local frames are inertial if and only if they measure the same accelerations for all particles.

5. A local frame is inertial if and only if a perfect accelerometer at rest measures no acceleration.

Also:

6. A local frame is inertial if and only if physical laws are observed to be in their simplest forms.

 

This seemed simple enough and I hoped to continue with classical physics, but I was bothered that "local" is opposed to "global" and that global should refer to the shape of the whole universe, not merely the difference between free falling near the Earth and floating relatively nearby in space, which seems "local" with respect to the entire universe. Then I realized I still had the above problem. If one obserever is free falling above Earth's atmoshpere and the other observer is in low Earth orbit, and if the free falling and orbiting observers pass through the same event, i.e., the same point in space at the same time, then, at that event, i.e., that point on the spacetime manifold, both observers should have the SAME set of local inertial frames, since they are passing through the same point in space at the same time and both of their accelerometers read zero. But they can't be in the same inertial frame since each observer measures the other as accelerating.

 

So it seems I can't avoid certain general-relativistic ideas, even when trying to avoid them and just stick to classical physics.

 

Any help with the resolution of this paradox will be greatly appreciated.

 

Thanks in advance.

 

P.S. I would like to avoid the mathematical formalism of special or general relativity, if possible, in the resolution of this problem. Intuitively, I strongly suspect it isn't needed, as these ideas are fundamental to an understanding of inertial frames, and as such should be relatively simple to explain.

Link to comment
Share on other sites

I'm reviewing physics after ~30yrs of neglect, starting with Halliday & Resnick (and the internet).

 

Here's what I understand to be standard Newtonian/classical inertial frames:

1. There exists a set of reference frames, called inertial frames, in which mass, time, force, acceleration, etc. are (Galilean) invariant but position, velocity, translational and angular momentum, work, kinetic energy, etc. aren't.

2. Measurements in one inertial frame can be converted into measurements in another frame by a Galilean transformation of coordinates.

3. All inertial frames are in relative rectilinear motion.

4. Any two frames are inertial if and only if they measure the same accelerations for all particles.

5. A frame is inertial if and only if a perfect accelerometer at rest measures no acceleration.

Also:

6. A frame is inertial if and only if physical laws are observed to be in their simplest forms.

 

When I got to the Equivalence principle:

1. Inertial mass = gravitational mass.

2. No experiment can determine whether you're in a free falling elevator or an elevator floating out in space. It is understood that the free falling elevator is just above the Earth's atmosphere and that the elevator in space is far from any gravitational source. Also, the free falling elevator is small enough, and falls for a short enough time period, that tidal deviations are below the level of experimental detection.

 

I had the following problem: I realized that #5 above was not true in the classical sense. Given two observers, each with a damped-spring accelerometer, one observer is in free fall above Earth's atmosphere and the other is floating out in space, then each observer will see that both accelerometers measure zero acceleration, even though they are accelerating with respect to each other. Each observer knows that his zero acceleration measurement proves that he is in an inertial frame, but also can see that the other observer's accelerometer aslo measures zero acceleration, that that therefore the other observer must also be in an inertial frame. And yet each observer clearly measures, in thier own inertial frame, that the other observer is accelerating.

 

I had assumed I would be able to do classical physics without having to worry about relativity, and that I could do relativity when I was ready. I guess was wrong.

 

I tried several things to get around the problem:

1. #5 above isn't really Newtonian, it must actually be an idea from relativity. This doesn't work since it can clearly be seen that #3-#5 above are all more or less equivalent.

2. I reasoned that the speeds and gravitaional fields involved were not relativistic, that somehow then the problem should go away and that the frames involved should be able to be described as noninertial in the classical sense. But this leads nowhere, if my accelerometer reads zero. I'm in an inertial frame.

3. I tried to convince myself that the 2 observers can't read each other's accelerometer, i.e., a signal sent between them would somehow be messed up by some "relativistic effect," but I knew this was rediculous since the speeds and field strengths involved weren't relativistic.

 

I gave up and opened my old general relativity book (Gravitation by MTW). The 1st chapter describes inertial motion:

Following a geodesic (free fall, orbit, etc.) = natural (weightless) motion of a particle = local inertial (i.e., Lorentz) frame = particles move at constant speed in straight lines. Physics (physical laws) is simple when viewed locally.

 

So I tried to revise my definition of an inertial frame:

1. For any particle moving in Nature, there exists a set of local reference frames, called inertial frames, in which mass, time, force, acceleration, etc. are (Lorentzian) invariant but position, velocity, translational and angular momentum, work, kinetic energy, etc. aren't.

2. Measurements in one local inertial frame can be converted into measurements in another local frame by a Lorentzian transformation of coordinates (Galilean at low speed).

3. All local inertial frames are in relative rectilinear motion.

4. Any two local frames are inertial if and only if they measure the same accelerations for all particles.

5. A local frame is inertial if and only if a perfect accelerometer at rest measures no acceleration.

Also:

6. A local frame is inertial if and only if physical laws are observed to be in their simplest forms.

 

This seemed simple enough and I hoped to continue with classical physics, but I was bothered that "local" is opposed to "global" and that global should refer to the shape of the whole universe, not merely the difference between free falling near the Earth and floating relatively nearby in space, which seems "local" with respect to the entire universe. Then I realized I still had the above problem. If one obserever is free falling above Earth's atmoshpere and the other observer is in low Earth orbit, and if the free falling and orbiting observers pass through the same event, i.e., the same point in space at the same time, then, at that event, i.e., that point on the spacetime manifold, both observers should have the SAME set of local inertial frames, since they are passing through the same point in space at the same time and both of their accelerometers read zero. But they can't be in the same inertial frame since each observer measures the other as accelerating.

 

So it seems I can't avoid certain general-relativistic ideas, even when trying to avoid them and just stick to classical physics.

 

Any help with the resolution of this paradox will be greatly appreciated.

 

Thanks in advance.

 

P.S. I would like to avoid the mathematical formalism of special or general relativity, if possible, in the resolution of this problem. Intuitively, I strongly suspect it isn't needed, as these ideas are fundamental to an understanding of inertial frames, and as such should be relatively simple to explain.

What the two observers measure about themselves is PROPER acceleration.

What the two observers measure about each other is COORDINATE acceleration.

Coordinate acceleration is DIFFERENT from proper acceleration.

Link to comment
Share on other sites

PeterDonis at

https://www.physicsforums.com/threads/inertial-reference-frames.797217/

gave an excellent explanation, definitely worth a read. I'm no longer confused about these ideas.

He gave you the same answer I gave you relative to co-mingling of proper and coordinate acceleration:

 

 

 

"No, they're not, because the word "acceleration" has two different meanings, and #3/#4 use one meaning while #5 uses the other. The first meaning (used in #3/#4) is called "coordinate acceleration" in relativity--it means a change in speed relative to some system of coordinates. The second meaning (used in #5) is called "proper acceleration" in relativity--it means what is measured by an (ideal) accelerometer. As should be evident from my discussion of #5 above, these two concepts are different and there is no necessary correlation between them even in Newtonian physics. So you can't derive #5 from #3/#4 in Newtonian physics"
In essence , the same answer I gave you earlier in the thread. Sure, he took the time to correct your other misconceptions, I only addressed your final question.

Edited by xyzt
Link to comment
Share on other sites

Feynman on inertia, which a local accelerometer is measuring.

 

>>

I went to my father and said, “Say, Pop, I noticed something. When I pull the wagon, the ball rolls to the back of the wagon. And when I’m pulling it along and I suddenly stop, the ball rolls to the front of the wagon. Why is that?” “That, nobody knows,” he said. “The general principle is that things which are moving tend to keep on moving, and things which are standing still tend to stand still, unless you push them hard. This tendency is called ‘inertia,’ but nobody knows why it’s true.” Now, that’s a deep understanding.

<<

 

also with video:

http://www.haveabit.com/feynman/2

Link to comment
Share on other sites

 

This seemed simple enough and I hoped to continue with classical physics, but I was bothered that "local" is opposed to "global" and that global should refer to the shape of the whole universe, not merely the difference between free falling near the Earth and floating relatively nearby in space, which seems "local" with respect to the entire universe. Then I realized I still had the above problem. If one obserever is free falling above Earth's atmoshpere and the other observer is in low Earth orbit, and if the free falling and orbiting observers pass through the same event, i.e., the same point in space at the same time, then, at that event, i.e., that point on the spacetime manifold, both observers should have the SAME set of local inertial frames, since they are passing through the same point in space at the same time and both of their accelerometers read zero. But they can't be in the same inertial frame since each observer measures the other as accelerating.

 

So it seems I can't avoid certain general-relativistic ideas, even when trying to avoid them and just stick to classical physics.

 

Any help with the resolution of this paradox will be greatly appreciated.

 

Thanks in advance.

 

P.S. I would like to avoid the mathematical formalism of special or general relativity, if possible, in the resolution of this problem. Intuitively, I strongly suspect it isn't needed, as these ideas are fundamental to an understanding of inertial frames, and as such should be relatively simple to explain.

Here is another way of showing that there is no paradox:

 

1. Using the Equivalence Principle, we can consider that the hovering observer is accelerating AWAY from the Earth, someplace far away in space, where there is no gravitating body. This observer measures a non-null proper acceleration and also measures the other observer accelerating past him TOWARDS the Earth (the acceleration he measures is coordinate acceleration)

 

2. The freefalling observer measures a null proper acceleration for himself and a non-null coordinate acceleration for the other observer (moving AWAY from the Earth).

 

No paradox.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.